Hi everyone-
I have a NetDimm that is fully working, however has bad/bent omron connectors. I have a 100% perfectly working non-net dimm. Would it work if I switched the non-nett's bottom board with good connectors into the net-dimm with bad connectors? On visual inspection, the bottom boards are identical with (presumably) only different firmware.
I was thinking if that worked, then maybe I could run the 3.17 upgrade on it, and presto-chango, 3.17 net dimm.
Thoughts?
Will this work? (dimm parts mix and match)
Hmm judging by the responses (thanks by the way!) I don't think I was clear with my question.
Ok, so I have a working non-net "core board", and a working net "top board". Will combining them work?
Sorry if you guys did answer it above, I just wanna be sure before I fry my only working dimm hehe.
-Bill
Ok, so I have a working non-net "core board", and a working net "top board". Will combining them work?
Sorry if you guys did answer it above, I just wanna be sure before I fry my only working dimm hehe.
-Bill
billd420 wrote:Hmm judging by the responses (thanks by the way!) I don't think I was clear with my question.
Ok, so I have a working non-net "core board", and a working net "top board". Will combining them work?
Sorry if you guys did answer it above, I just wanna be sure before I fry my only working dimm hehe.
-Bill
No you can mix an old non net dimm core with a net top part, you will error 22.
You can only mix the net core board and old top part.