Sega-Naomi

I have Monkeyball with the B.Stick.

When I make in my Naomi net city the stick not work.

Only start work!

Where is the Problem???

Thanks

The Banana stick is an analog joystick, in contrast to the digital joystick that probably was on the CP that you pulled from the cab.



Try reading this post first:



http://www.sega-naomi.com/forum/viewtopic.php?t=1742

It looks from the picture that you cabinet is a JPN with Tyco connectors.



Also based on the fact you are in germany I would also guess your cabinet is JPN with Tyco connectors.



If so all you need is the 'Y' harness. (Not expensive)



Geezer has them.



NOA-60061 [Analogue Splitter Loom]

This is the analogue splitter loom and is required for several analogue control panels Sega made, such as Monkey Ball and Zombie Revenge.





http://triplemoonstar.brinkster.net/seg ... ockid=1733



Hook one end to player 1 and 2 analog conectors on cabinet



The other end to analog connector on Monkey Ball panel





Bob Presutti

SkiDog wrote:It looks from the picture that you cabinet is a JPN with Tyco connectors.



Also based on the fact you are in germany I would also guess your cabinet is JPN with Tyco connectors.



If so all you need is the 'Y' harness. (Not expensive)



Geezer has them.



NOA-60061 [Analogue Splitter Loom]

This is the analogue splitter loom and is required for several analogue control panels Sega made, such as Monkey Ball and Zombie Revenge.





http://triplemoonstar.brinkster.net/seg ... ockid=1733



Hook one end to player 1 and 2 analog conectors on cabinet



The other end to analog connector on Monkey Ball panel





Bob Presutti

Thanks! :smt006

I think the cabelk is not right!The Plug hast 10 but in naomi hast 15?

Please look on the Picture , the Plug is not right.

Darky wrote:I think the cabelk is not right!The Plug hast 10 but in naomi hast 15?

Please look on the Picture , the Plug is not right.

Connector 1 goes to connector 1



For the other...



You need to use the two bottom yellow and white 8 pin connectors



The loom from Geezer has two 8 pin connectors on one end (yellow and white) and a 10 pin connector on the other end to plug into your monkey ball panel (connector 2)



Bob Presutti

SkiDog wrote:

Darky wrote:I think the cabelk is not right!The Plug hast 10 but in naomi hast 15?

Please look on the Picture , the Plug is not right.

Connector 1 goes to connector 1



For the other...



You need to use the two bottom yellow and white 8 pin connectors



The loom from Geezer has two 8 pin connectors on one end (yellow and white) and a 10 pin connector on the other end to plug into your monkey ball panel (connector 2)



Bob Presutti

Thanks !