I am trying to set up a World Series baseball in a New Astro City cabinet. I have the control panel and the analog controls all plug into the 10 pin kick harness.
Where on the Naomi I/O or Motherboard do the analog controls plug into?
I cannot see where these connections are supposed to route.
Was there another harness I am missing that plugs into the kick harness and hooks up to something?
Thanks.
World Series Baseball Analog connections
I have the Sega I/O. It is Jamma and it says SP-5002A on the label that is on the biggest chip.
Is there a prebuilt cable that would normally come with the control panel?
In the manual that came with it I saw a schematic that showed which wires were which, but it did not seem to have a schematic for the I/O.
I can submit a photo of the I/O if needed.
Is there a prebuilt cable that would normally come with the control panel?
In the manual that came with it I saw a schematic that showed which wires were which, but it did not seem to have a schematic for the I/O.
I can submit a photo of the I/O if needed.
If your cab is not wired for JVS, connecting analog inputs to the Sega I/O can be done with this harness:
http://triplemoonstar.brinkster.net/the ... ockid=1690
http://triplemoonstar.brinkster.net/the ... ockid=1690
Cageman wrote:If your cab is not wired for JVS, connecting analog inputs to the Sega I/O can be done with this harness:
http://triplemoonstar.brinkster.net/the ... ockid=1690
Is this harness compatible with the Capcom I/O? Can the Capcom I/O receive the analogue swing signal for World Series or Dynamite Baseball?
NOAH wrote:Cageman wrote:If your cab is not wired for JVS, connecting analog inputs to the Sega I/O can be done with this harness:
http://triplemoonstar.brinkster.net/the ... ockid=1690
Is this harness compatible with the Capcom I/O? Can the Capcom I/O receive the analogue swing signal for World Series or Dynamite Baseball?
No, the Capcom I/O is a JAMMA I/O. The JAMMA standard does not allow for analog connections.
Cageman wrote:NOAH wrote:Cageman wrote:If your cab is not wired for JVS, connecting analog inputs to the Sega I/O can be done with this harness:
http://triplemoonstar.brinkster.net/the ... ockid=1690
Is this harness compatible with the Capcom I/O? Can the Capcom I/O receive the analogue swing signal for World Series or Dynamite Baseball?
No, the Capcom I/O is a JAMMA I/O. The JAMMA standard does not allow for analog connections.
Thanks, Cageman. Though it's bad news for me, it's good to be a little closer to getting things going.