Page 1 of 2
Where to buy Naomi flybacks?
Posted: Wed Aug 25, 2010 10:09 am
by OldFoo
Hi, i have some isssues with my 29E31S monitor. Where can i buy a flyback replacement?
Thanks!
Posted: Wed Aug 25, 2010 12:18 pm
by OldFoo
Welcome
Best bet would be to contact Craig at
http://giz10p.co.uk . He has a lot of monitor/chassis expertise, and might have one of these available for you.
Posted: Wed Aug 25, 2010 12:35 pm
by OldFoo
Cageman wrote:Welcome
Best bet would be to contact Craig at
http://giz10p.co.uk . He has a lot of monitor/chassis expertise, and might have one of these available for you.
He replied me very briefly that he hasn't that part :'(
Posted: Wed Aug 25, 2010 12:47 pm
by OldFoo
Ok.. PM grantspain on this forum. Provide photo's and a little more explanation if you are uncertain if it is the LOPT. If it is, grantspain can probably tell you were to get a replacement.
Posted: Wed Aug 25, 2010 12:50 pm
by OldFoo
Posted: Wed Aug 25, 2010 1:10 pm
by OldFoo
according to this:
http://hrshop-fr.com/index.php?command= ... 70&offset=
it uses an HR46274
but i wouldn't trust that with a 10 foot pole, maybe contact jomac,
http://www.jomac.net.au/ .
Posted: Wed Aug 25, 2010 2:57 pm
by OldFoo
Cageman wrote:Ok.. PM grantspain on this forum. Provide photo's and a little more explanation if you are uncertain if it is the LOPT. If it is, grantspain can probably tell you were to get a replacement.
Thanks my friend, i've written , now wait for reply.
Very useful , thanks. Lamentably HR shop in SPAIN have rejected my request and and have not wanted to commit to anything :'(
JOMAC says that they can't help me.
I've found a store but i don't hear about it before. At least they reply to my mails.
I hope the HR46274 was the answer to my problem :S I'm afraid it won't be 100% compatible.
Posted: Wed Aug 25, 2010 6:21 pm
by OldFoo
are you sure your flyback is bad?
Posted: Wed Aug 25, 2010 11:06 pm
by OldFoo
KI4SWY wrote:are you sure your flyback is bad?
Not sure 100%.
I have focus problems and if i compress the image get barrel efect.
What do you think?
The focus problem only "disappear" if i adjust it with contrast & brightness but get poor image.
Like that.
Posted: Wed Aug 25, 2010 11:39 pm
by OldFoo
check the heater voltage & B+
