Hello,
I'm new here, and I've just purchased a nice Naomi cab!
I've lurked the forum for a while, and after seeing many cool projects in here I decided to go as well for this beautiful cab.
I don't really have any JVS experience, so forgive me if this sounds dumb...
my cab came with Virtua Strikers 3 and 2p3b, but I would like to change that and make it a 6 buttons for each player.
I've seen on another post that I need this:
http://www.giz10p.co.uk/Cabinet-Parts/W ... od_85.html
but I'm wondering where it should be plugged. Below pictures of my I/O device
Uploaded with ImageShack.us
Uploaded with ImageShack.us
Hope you guys can advice me on what to do, and if I need additional wires.
Thanks a lot
6 buttons in Naomi cab
Unfortunately they are out of stock in both sites
After reading in the product details of the extra button loom on Segashed the following:
"Although the plug is a 10pin AMP connector, it plugs into the 15pin AMP connector on UK Naomi's.".
I was wondering if they might refer to the one I have in the lower part. If that would be the case I wouldn't need to get the whole kick harness and just the loom right?
After reading in the product details of the extra button loom on Segashed the following:
"Although the plug is a 10pin AMP connector, it plugs into the 15pin AMP connector on UK Naomi's.".
I was wondering if they might refer to the one I have in the lower part. If that would be the case I wouldn't need to get the whole kick harness and just the loom right?