6 buttons in Naomi cab

OldFoo · Post by **OldFoo** » Fri Sep 30, 2011 7:36 pm

Hello,

I'm new here, and I've just purchased a nice Naomi cab!

I've lurked the forum for a while, and after seeing many cool projects in here I decided to go as well for this beautiful cab.

I don't really have any JVS experience, so forgive me if this sounds dumb...

my cab came with Virtua Strikers 3 and 2p3b, but I would like to change that and make it a 6 buttons for each player.

I've seen on another post that I need this:

http://www.giz10p.co.uk/Cabinet-Parts/W ... od_85.html

but I'm wondering where it should be plugged. Below pictures of my I/O device

Uploaded with ImageShack.us

Uploaded with ImageShack.us

Hope you guys can advice me on what to do, and if I need additional wires.

Thanks a lot

OldFoo · Post by **OldFoo** » Fri Sep 30, 2011 8:40 pm

Hi you need a kick harness and it goes in the white plug to the right of the yellow plug.

John

OldFoo · Post by **OldFoo** » Fri Sep 30, 2011 10:17 pm

Morrigu99 wrote:Hi you need a kick harness and it goes in the white plug to the right of the yellow plug.

John

thanks for the reply John!

any advice on where i could get one of those kick harnss?

By the way, what are the three plugs below the p1 and p2 cables used for?

OldFoo · Post by **OldFoo** » Sat Oct 01, 2011 6:51 am

Hi check out Andy geezer at sega shed or Craig at giz10p both have these cables. I think the other plugs are for analogue controls ( trackball steering wheels etc....)

John

OldFoo · Post by **OldFoo** » Sat Oct 01, 2011 12:40 pm

Unfortunately they are out of stock in both sites

After reading in the product details of the extra button loom on Segashed the following:

"Although the plug is a 10pin AMP connector, it plugs into the 15pin AMP connector on UK Naomi's.".

I was wondering if they might refer to the one I have in the lower part. If that would be the case I wouldn't need to get the whole kick harness and just the loom right?