Page 1 of 1
Quick question about Hotd 2 gun to gunboard.
Posted: Fri Dec 16, 2011 5:47 pm
by OldFoo
Ok, have a Hotd 2 gun with a 8 pin AMP. This is supposed to go on the 7 pin connector on my gunboard. I know where everything is supposed to go but the question is about the 8:th wire (ground).
Well, exactly where should it be connected? Anywhere ground on the 26/60 JST RH connector?
Thanks
Posted: Fri Dec 16, 2011 7:56 pm
by OldFoo
Was that the white one?
Posted: Fri Dec 16, 2011 9:57 pm
by OldFoo
Yes.
Posted: Fri Dec 16, 2011 11:48 pm
by OldFoo
Left unconnected job done?
That's the way it is with mine, hope this helps
Posted: Sat Dec 17, 2011 10:18 am
by OldFoo
Thanks.
Posted: Mon Dec 26, 2011 6:40 pm
by OldFoo
Ok, more problems...
We have now fired up our Gunboard with 12v (VCC) but:
When we measure pin 7 on Gun 1 and Gun 2 on the Gunboard (which is the 12 V pin) it doesn't read anything. The other pin on the gunboard that should have 12v have it (LED connector). My thoughts about this is that we must power this one up separately? I.e. The VCC 12v does not power these connectors?
Or faulty board. :smt010
If the Gun 1 and 2 doesn't work due to this, is it possible to connect the Gun to the Naomi i/o or are we totally screwed?
Thanks