MvsC II Video problem
Posted: Mon Apr 02, 2012 1:21 am
Gentlemen, I have a marvel vs capcom II game. I received the cabinet and Naomi system from different sources, and almost have all of the kinks worked out of the merger. However, I cannot get my video to function properly.
When I turn it on, the screen is scrolling vertically (but it is clearly the game demo playing and the sound if perfect).
I have explored the entire range of the pods on the monitor. Although I can temporarily stop the scrolling, the top of image is dragged left and the bottom is dragged right.
I know the rule of dip switch 1, and mine is correct (15). I did switch it to high just to see what would happen, and the picture becomes crystal clear, but is split into the dual image phenomena, so I switched it back.
Something else that is strange about it is, as I said, I can stop the scrolling with the pod (although still dragged), but only during certain cut scenes through the game intro sequence. And each time the demo goes to a new scene, my stable (yet dragged) screen begins scrolling again. Is this maybe a board problem internally?
I am using a K7000 that I use all of the time as my test screen, and never have any problems with it. I have even hooked up one of my jamma test boards to the harness, used the pods to get it crystal clear, then shut it all down and switched the harness back to the Naomi's converter. The scrolling was there in full force. Please grant me your wisdom because, as you can tell, I am struggling.
When I turn it on, the screen is scrolling vertically (but it is clearly the game demo playing and the sound if perfect).
I have explored the entire range of the pods on the monitor. Although I can temporarily stop the scrolling, the top of image is dragged left and the bottom is dragged right.
I know the rule of dip switch 1, and mine is correct (15). I did switch it to high just to see what would happen, and the picture becomes crystal clear, but is split into the dual image phenomena, so I switched it back.
Something else that is strange about it is, as I said, I can stop the scrolling with the pod (although still dragged), but only during certain cut scenes through the game intro sequence. And each time the demo goes to a new scene, my stable (yet dragged) screen begins scrolling again. Is this maybe a board problem internally?
I am using a K7000 that I use all of the time as my test screen, and never have any problems with it. I have even hooked up one of my jamma test boards to the harness, used the pods to get it crystal clear, then shut it all down and switched the harness back to the Naomi's converter. The scrolling was there in full force. Please grant me your wisdom because, as you can tell, I am struggling.