monitor sanwa help

Naomi & all other arcade tech questions forum
Post Reply
OldFoo

monitor sanwa help

Post by OldFoo »

Hi guys,

jut two question if you can help me



1) i had a toshiba tube a68ksm696x with a broken nanao chassis; as written on the service manual, this tube is compatible with the sanwa 29e31s chassis: i installed it, the monitor worked for few sec (the picture was reversed, dont know why) and then died. Now i can hear the "voltage" sound, i checked the input voltage and was ok, but when i turn it on no picture at all... any idea?





2) i have another monitor sanwa 29pfx 3sync; as per service manual, it need VGA input, voltage (3 pin 110 or 220) and video signal for old 15/25 khz games (8 pin connector matching the ones on the jamma fingerboard). My question is: if i use it on a jvs system like naomi, do i need to wire also this 8 pin connector or i just need vga+110? I didnt try yet



thanks
Post Reply