Hi,
I bought a Dimm board recently which arrived saterday and it doesn't work. When I insert the dimm in my Naomi mobo and I turn it on the screen stays black. Running the Naomi without cart works and with 2 different carts also works perfectly.
Checked my voltages and they're 5.12, 3.29 and 12.13
Seller sold it to me as working and he sent me pictures from the test menu of a working dimm before I bought it, so it should be fine.
Bought a dimm board before which was broke (error 22) but at least gave me a screen showing the error. This one does nothing at all.
Tried to clean the dimm (a lot of white wash on the bottom of the pcb) and reseated it several times to make sure it connects good.
Any suggestions what to do?
Thanks in advance
dimm board not working
elbauju wrote:Is it a netdimm ?
On mine, I have to wait 30/40 seconde before showing boot screen.
I have this delay, since I have put jumper dimm in network config.
Maybe you don't wait enough time before shuting down the cab ?
Andy, is it possible to remove this delay ?
IF you set the networking to none it will speed it up a few seconds, but not much you can do - can't remember if you use an old top board will speed it up as it removes the networking (yet VF4FT will still work).
Jackalus wrote:I took the DIMM back now, he had WRONG DIP settings!!!!!!!
With wrong dip setting (Netboot setting) it just shows blackscreen...
It works just fine.
GDROM status is bad because I have no drive to test with atm.
:smt013 :smt013 :smt013 :smt013 :smt013 :smt013 :smt013
Don't think 1.02 dimm boards have network setttings, cause they don't even have network controller on there..