Hi all,
I open this topic for you lindberg guru as I would like to understand how to create a backup of my original Lindberg (no matter the game).
I tried connecting the hard drive on a fresh motherboard from asrock but I get a "primary slave error" on bios post screen, no matter changing the jumper from slave/master.
I think I just need to have my drive "prepared" (I mean partition prepared) in order to install the game from test menu and using the dvd drive with dvd disk.
Sorry if I'm not in line with forum's policy, but I really need your help.
Thank you in advance any way.
Best regards,
Francesco
Lindberg (Yellow) - Hard Drive Cloning
Lindbergh HD
Not need to do anything, just install the new hard drive on the lindbergh.
And put the installation DVD on the Lindbergh DVD drive.
The HD Must be configured as SLAVE DEVICE, the CF on the motherboard is the Master one.
If you get a Error from the Bios, can be because the HD is not acceptable.
Lindbergh only accepts 40Gbytes HD's and only some specific models, like WD WD400BB Caviar and Hitachi DeskStar HDS728040PLAT20, one or two models more.
You can try to move the jumper near the CR20232 battery from 1-3 position to 1-2 and boot the lindbergh until you get a CMOS Reset error, then power off and put the jumper back to 1-3 and boot again.
Only 40Gbytes HDs that supports ATA Password Looking are supported by the lindbergh.
And put the installation DVD on the Lindbergh DVD drive.
The HD Must be configured as SLAVE DEVICE, the CF on the motherboard is the Master one.
If you get a Error from the Bios, can be because the HD is not acceptable.
Lindbergh only accepts 40Gbytes HD's and only some specific models, like WD WD400BB Caviar and Hitachi DeskStar HDS728040PLAT20, one or two models more.
You can try to move the jumper near the CR20232 battery from 1-3 position to 1-2 and boot the lindbergh until you get a CMOS Reset error, then power off and put the jumper back to 1-3 and boot again.
Only 40Gbytes HDs that supports ATA Password Looking are supported by the lindbergh.
Re: Lindbergh HD
android wrote:Not need to do anything, just install the new hard drive on the lindbergh.
And put the installation DVD on the Lindbergh DVD drive.
The HD Must be configured as SLAVE DEVICE, the CF on the motherboard is the Master one.
If you get a Error from the Bios, can be because the HD is not acceptable.
Lindbergh only accepts 40Gbytes HD's and only some specific models, like WD WD400BB Caviar and Hitachi DeskStar HDS728040PLAT20, one or two models more.
You can try to move the jumper near the CR20232 battery from 1-3 position to 1-2 and boot the lindbergh until you get a CMOS Reset error, then power off and put the jumper back to 1-3 and boot again.
Only 40Gbytes HDs that supports ATA Password Looking are supported by the lindbergh.
Hi android and thank you very much for sharing your knowledge with me.
Just one more question, why you suggest me to bring the Lindy in CMOS Reset error?