ok it's good , not problem dimm 0 .
you are the error 24 now ??
your GDDrive is conneceted, the CD Spining ?
if you have a dreamcast, replace the lens of the dreamcast in the GDrom drive and test it .
Warning : please take take your time for connect the alimentation, if you plug the alimentation in the bad sens, your lens is destroy and possibility of error 24 !!!!!!!!
Error Code 24
Ok- so I got my replacement lens and I have an issue.
I didn't realize there were 2 versions. I have a 610-0617-01
and I got the 610-0617 replacement. So I cannot just swap the unit.
Should I replace the lens assembly, or am I screwed? Looks like the board
is different, the scussi and power inputs are not soldered onto my replacement board. Any suggestions? Am I going to have to transfer the inputs, is that even possible?
I didn't realize there were 2 versions. I have a 610-0617-01
and I got the 610-0617 replacement. So I cannot just swap the unit.
Should I replace the lens assembly, or am I screwed? Looks like the board
is different, the scussi and power inputs are not soldered onto my replacement board. Any suggestions? Am I going to have to transfer the inputs, is that even possible?
Any updates on this?
I recently purchased a twin initial D Ver2. cabinets, and Player 2 is now getting a ERROR 24 as well. I tried the P2 GD-Rom in the P1 cabinet, and it worked, so I am still at a loss...
Did you resolve yours?
Thanks,
Saloon
I recently purchased a twin initial D Ver2. cabinets, and Player 2 is now getting a ERROR 24 as well. I tried the P2 GD-Rom in the P1 cabinet, and it worked, so I am still at a loss...
Did you resolve yours?
Thanks,
Saloon
Last edited by OldFoo on Mon Jan 18, 2010 11:14 pm, edited 1 time in total.
fantoboy wrote:Ok- so I got my replacement lens and I have an issue.
I didn't realize there were 2 versions. I have a 610-0617-01
and I got the 610-0617 replacement. So I cannot just swap the unit.
Should I replace the lens assembly, or am I screwed? Looks like the board
is different, the scussi and power inputs are not soldered onto my replacement board. Any suggestions? Am I going to have to transfer the inputs, is that even possible?
Lens/motor unit is the same on both versions. You'll have to remove the lens motor unit from your replacement lens unit and place it in your gd-rom drive.