Where can I find an EPROM Puller for my Naomi Board?

OldFoo · Post by **OldFoo** » Thu Jul 29, 2010 9:00 pm

Please help me locate an Eprom Puller for my Naomi Board.

I dont feel comfortable using the screwdriver technique after trying it before, Long story short Ill never do it again.

Please help me locate one.

Im sure others are interested in getting one as well.

Appreciate the help,

Justin

OldFoo · Post by **OldFoo** » Thu Jul 29, 2010 9:43 pm

http://mikesarcade.com/cgi-bin/store.pl?sku=CPULLER

OldFoo · Post by **OldFoo** » Thu Jul 29, 2010 9:52 pm

englishman_in_plantcity wrote:http://mikesarcade.com/cgi-bin/store.pl?sku=CPULLER

Hey thanks, I even tried Mikesarcade.

I just used the wrong search word. "eprom"

it gave me zero results. Ill pick one up.

Has anyone tried this one? What did you think of it?

thanks

OldFoo · Post by **OldFoo** » Thu Jul 29, 2010 9:56 pm

Radioshack would surely sell them too ?

In the UK Maplin sell them.

OldFoo · Post by **OldFoo** » Thu Jul 29, 2010 10:20 pm

I use the one from Mikes Arcade and works fine for me, much easier than a butter knife or screwdriver

OldFoo · Post by **OldFoo** » Thu Jul 29, 2010 10:40 pm

hey, plastic butter knifes work good.

OldFoo · Post by **OldFoo** » Thu Jul 29, 2010 10:44 pm

englishman_in_plantcity wrote:I use the one from Mikes Arcade and works fine for me, much easier than a butter knife or screwdriver

Exact same one that I have.

OldFoo · Post by **OldFoo** » Thu Jul 29, 2010 10:48 pm

KI4SWY wrote:hey, plastic butter knifes work good.

yeah and your meant to be the smart tech

OldFoo · Post by **OldFoo** » Fri Jul 30, 2010 7:13 am

I prefer a small flat headed screwdriver.

If you get the cheap ones that have a pocket clip on them you can bend them at a right angle about 1" from the tip and use it to lift alternating sides of the chip.

If those silly U-shaped ones slip on one side then you end up with some massively bent pins on the chip.

OldFoo · Post by **OldFoo** » Fri Jul 30, 2010 11:12 am

channelmaniac wrote:I prefer a small flat headed screwdriver.

If you get the cheap ones that have a pocket clip on them you can bend them at a right angle about 1" from the tip and use it to lift alternating sides of the chip.

If those silly U-shaped ones slip on one side then you end up with some massively bent pins on the chip.

hence why i dislike those u shaped things