Connect a namco STR PCB to Triforce w/ sega IO bd ?

OldFoo · Post by **OldFoo** » Tue Oct 26, 2010 1:19 pm

Does anyone knows to what the pin "A7" with "POWER" indication from FCA PCB on MK diagram corresponds to?

cause this pin is also conencted to FFB PCB on the same wiring with STRV-OUT and GND?

THKS

OldFoo · Post by **OldFoo** » Thu Oct 28, 2010 12:45 pm

If your the guy on gamoover.net, then your namo str PCB is not a Mario Kart type.

OldFoo · Post by **OldFoo** » Thu Oct 28, 2010 3:06 pm

ok merci.

OldFoo · Post by **OldFoo** » Thu Oct 28, 2010 4:55 pm

Namco drive board for Mario Kart

Also found on WMMT1 and 2 and Ridge Racer 5

IC16 needs to be programmed up for each game.

OldFoo · Post by **OldFoo** » Fri Oct 29, 2010 4:23 pm

thx for the picture.

It looks like mine but with the apropriated IC16 programmation.

And certainly that it needs namco stuff like IO and so on ... to work properly

Anyway i will play namco racing game on my sega cab without FFB :smt010 but always with pleasure

OldFoo · Post by **OldFoo** » Fri Oct 29, 2010 4:24 pm

thx for the picture.

It looks like mine but with the apropriated IC16 programmation.

And certainly that it needs namco stuff like IO and so on ... to work properly

Anyway i will play namco racing game on my sega cab without FFB :smt010 but always with pleasure

THX

OldFoo · Post by **OldFoo** » Sat Oct 30, 2010 10:21 am

superplac wrote:thx for the picture.

It looks like mine but with the apropriated IC16 programmation.

And certainly that it needs namco stuff like IO and so on ... to work properly

Anyway I will play namco racing game on my sega cab without FFB :smt010 but always with pleasure

no it doesn't need namco i/o.. Sega is fine, just needs to be the correct IC16 rom dump, and have the TX/RX correctly wired.